fiberglass installation
Measure the total area of the walls to be insulated: All measurements should be taken of the walls to be insulated, and the number of wall gaps to be isolated as well.
Choosing the appropriate fiberglass coil: The degree of filler of fiberglass varies depending on the wall to be insulated; Each site of the house has its own degree of insulation, and this degree is symbolized by (English: R), where the value of the thermal resistance of the insulating material appears. The higher this value, the more efficient this material is in the insulation process.
Preparing the tools and equipment needed to start the insulation process: The necessary tools should be prepared to start the installation process, which are as follows:
Knife, or multi-use scalpel.
Safety equipment such as gloves, masks, pants, and long sleeves.
Iron clamp piston.
Cutting the fiberglass coils according to the measurements: After purchasing the insulation coils according to the measurements obtained from the site, they are carefully divided using the knife to obtain the appropriate width to be installed on it.
Fixing the fiberglass pieces: Each piece of insulation is pushed into the place to be insulated, and pulled out little by little, so that the gaps are completely filled.
Fastening the insulating material: Fastening is carried out using a piston of iron clamps, with a clamp approximately every 17.8 cm.
Use of insulation foam
Insulation foam is widely used to resist moisture, as it is often used in basements and attic floors, and the following are the steps of insulation using this material:
Determining the size of the area to be isolated: It is necessary to know the area to be isolated, as this type of insulation is suitable for isolating the attic area and basements, and this is done using a low-pressure sprinkler. .
Providing the necessary tools: The foam sprayer can be purchased from stores specializing in the sale of insulation materials, and its accessories, and although this machine is not cheap, it can be used to isolate small areas quickly and easily, in addition to the need to obtain safety equipment, where glasses should be purchased Eye protection, a mask, and it is preferable to wear a full work suit or replace it with sleeves and pants.
Choosing the right type of insulation foam: The appropriate type of insulation foam should be chosen, as there are two types of it, which are closed insulation foam, and open insulation foam, as closed foam is often used in the insulation of external walls; Because of its high resistance and greater efficiency compared to the open foam often used in interior walls, and closing small holes in drywall.
Preparing the area to be isolated: by removing the nails stuck to the walls, cleaning the debris, and preparing the wall to start the isolation process. The gaps in the walls should be identified, from which light can be seen, or an air stream should be observed through them, and it is preferable to identify them by placing a certain mark; To be referenced after insulation is completed; To ensure the quality of the insulation process.
TRANSLATED FROM:
