Swimming pool circulation pump maintenance

Comments · 159 Views

Elevate your swim season with Zealux! Our pool heat pumps boast a Max COP of 16, ensuring optimal efficiency and cost savings.

Swimming pool pump belongs to circulating water equipment, also known as swimming pool circulating pump. It is one of the important equipment of swimming pool engineering, and it is an important guarantee for the circulating water supply of swimming pool. Therefore, the normal use and maintenance of the swimming pool pump in daily work is very necessary. In addition, it is more efficient and energy-saving to choose the variable frequency circulating pump from Poolclub.

 

Heat Pump Supplier gives there are several points to note when using a swimming pool circulation pump:

First of all, you need to check before the pump is turned on: adjust the filter sand tank to the filtering state; check the valve; check whether the hair collector is blocked and whether there is air, if so, clean it in time; check whether the tank cover is leaking; inspection of the dosing tank. Check whether there is air accumulated in the main return water pipeline, and remove it through the drain valve if there is.

After opening, we also need to observe whether the swimming pool water pump is running normally, such as recording the index of the pressure gauge on the filter to check whether backwashing is carried out; check the operation of the water pump, whether it is running smoothly and low noise; check whether the dosing system is running normally; go to the swimming pool Visually check whether the water from each water injection port is normal. In short, it is to check whether all its connecting parts are normal. If there is a problem, you need to find the cause of the problem and solve it.

Swimming pool water pumps have many functions, and different functions require different aspects that we need to pay attention to: for example, filtration function: we need to pay attention to whether there is blockage, whether there is inflation, etc.; If the reading of the pressure gauge is higher than 2.5kg/cm2 or above, the filter sand tank needs to be backwashed immediately, and then turned on and used according to the instructions. Observe the clear water mirror during use, and when it is cleaned, turn off the backwash pump; during the drainage process We should try to prevent the water pump from being interrupted.

pool heater manufacturerpool heater manufacturers

 

The POOLCLUB company reminds you that the daily inspection of swimming pool equipment and water quality is a must, and once every two hours after opening, it is best to use automatic inspection and control to maintain the water quality balance.

After the coagulant is put into the swimming pool equipment, try to let the circulation system run for half an hour. If flocculent sediment is found in the water, it should be kept for 6-8 hours, and then the sediment should be discharged with sewage suction equipment. Be patient when sucking up.

Outdoor swimming pool equipment should pay attention to preventing the occurrence of algae in summer, especially in the rainy season, and add algaecide early before thunderstorms.

The most important factor affecting the quality of swimming pool equipment is the pH value. The best pH value of the pool water is 6.5-7.8. If the pH value is wrong, the previous efforts will be in vain!

Occasionally, the shaft seal ring of the motor will be worn and should be replaced in time. In winter, the accumulated water in the pump should be removed, the inside and outside of the pump should be cleaned, and the pump should be stored in a dry and well-ventilated room.

If you need to buy a swimming pool circulating pump, POOLCLUB variable frequency pump is a very good choice. In addition to reducing energy consumption by 80%, it is also 25% lower in noise than other pumps of the same type during operation. It is a must for family swimming pools.

 

 

Tag: largest heat pump manufacturersheat pump wholesalersair to water heat pump manufacturer,  pompe à chaleur piscine inverter, luftwärmepumpen, wärmepumpenhersteller, inverter pool heat pump

Comments