Hydraulic Die Press Machine

Multi die Hydraulic Hot Press.
Frame: Made of MS Rod’s hard Chromed.
Daylight : 140 mm. Platens: Made of MS slab (25 mm) thick. Painted.
Platen Size : 8 x 8 (LW in inches).
Heating Block: Made of Aluminum Block (25 mm) thick.
Heaters: 4-rod type heater (350 W each) inserted in each heating block.
Temperature Range : Ambient to 250oC. +/- 2oC. LC 0.1oC.
Temperature Control: Two Digital PID controllers (one for each platen). The controllers are housed in separate panel box with heater and thermocouple connectors at the back. The mains are connected to an MCB. Each Platen heaters can be individually operated and controlled.
Pressure: Using a Manual Hydraulic system with the oil pump.
Hydraulic: Hydraulic Ramp diameter of 82.5 mm connected to lower platen.
Pressure Range : 0-250 KN (25 tons) +/- 5 KN (0.5 tons). LC 1.25 KN (0.125 tons) (1 ton = 9.964 KN).
Pressure Gauge: 0-250 KN stainless Steel Gauge connected to ramp dia.
Pump: Manual, using hydraulic oil (No 4.
Pressure Release: Using a manual valve given in the pump.
Water Cooling: Using running water through the drilled tunnel in the platen. (water pipe not part of this quote).
Calibration: Temperature controller / Dia Gauge to be calibrated from a NABL lab.

There are several dies made of stainless steel that are possible to supply at extra charges. The most popular are dies for Limiting oxygen index test and Smoke density test.

For more information, visit- https://www.techtrivial.com/pr....oduct/multi-die-hydr